Matronics Email Lists

Lockwood number for the yellow banded medium berry mount is 22001-12. They do make harder and softer mounts but I have settle on the medium.

Hope that helps,
Bill Coleman

From: &q ...

Check the welch plugs on the top of the carbs. I had one come loose which causes that diaphragm to get out of sync with the other carb.

Hope that helps,
Bill Coleman

On Jun 9, 2013, ...

If you have the original resistance fuel Level sending units, don't forget to check the electrical connection terminal packing seal. That fiber gasket/seal eventually dries out and leaks just enough ...

Dan Billings made the originals. He sold his Pulsar years ago so probably doesn't do them anymore, but if someone knew how to contact him he might have a set left over. I made mine which was not to ...

Some of us added a wrap of fiberglass or carbon fiber around the lower part of the leg. I used carbon fiber - about 1/2" wide wrapped around the very end of the leg and another just above the wh ...

I would be replacing that voltage regulator.

On Jun 16, 2012, at 1:49 PM, "sonja.englert@juno.com" <sonja.englert@juno.com> wrote:

Hello Group,
I have a problem w ...

Hi Greg,
Pat and I will make the event this year. Can't think of any topic of interest except to know how the Nova project is going.
Thanks for arranging it,
Bill Coleman

On May 16, 2 ...

I had that same problem and traced it to a bad ground. On mine it would only happen when I had several things turned on. Check to see if it changes depending on the electrical load. If so, check t ...

I used a Fox Vanilla FRFXV6515900 racing shock 6.5" X 1.5". As I recall, it came with a spring that was too heavy so I had to change the spring. Sorry, I cannot recall the spring rating fo ...