Matronics Email Lists

Why not just use a 3PDT (three pole) switch and put the headphones on there as well. If the ICOM is your primary radio, you'll note that it also has Aux In inputs. By wiring the other radio to one of ...

The Artex ME406 manual that I have is very clear that shielded 5 wire cable is only recommended. They further state that shielded 4 conductor cable can be used where the shield is used as the ground ...

If you're ordering terminals from Aircraft Spruce, I'd recommend that you double check the AMP part numbers on them. Hard to believe, but quite a while ago I ordered some butt splices from them and r ...

I think this article gives a good start for answering this question ... basically the conductive liner is preventing static sparks between the inside of the hose and the braid.

http://www.sacskyran ...

Rodney : Thanks for the re-inforcement that I'm really not going crazy as the grey hairs start increasing. I only wish I could get away with just +1.25 cheaters to see these markings ... they're some ...

Thanks Larry.

I think I was just being over cautious ... I'm doing this from scratch and first had to insert the polarizing key into my blank Molex connector. It does match the radio and I've loo ...

I'm currently wiring an A200 and like many others I thought I'd cross-check the very basic installation instructions that were provided. I've downloaded and looked at the http://www.aeroelectric.com/ ...