Matronics Email Lists

Does anyone happen to know what diameter ignition cables World Wide Warbird uses for their auto-ignition kits? We are replacing our mag cap and need to ream out the holes.

Thanks!

Mike

I'm at my wits end here. I've been chasing an ignition issue that first appeared when the aircraft was flown into some heavy precipitation. Basically we have a smooth running engine on start-up, wi ...

If factory code '320' is the factory in Nanchang, does anyone know where factory '512' was located?

Hey all,

Anyone know where I can get a small can (preferably spray) of the grass green chinese paint, or equivalent?

Thanks!

Mike

Does anyone have a hi-rez file of the PLAAF roundel they can email me?

Thanks!

Mike K

...and if your travels take you via Hong Kong then I can show you around and buy you a Tsing Tao beer down in Lang Kwai Fong or Wanchai.

Mike Kirk

Hey all!

There is a picture on the RPA website of a CJ with a pair of droptank-like containers mounted under the wings. From the address attached to the photo I'm assuming it's a Kiwi-based machin ...

Will the ground marshalling crews know to put us all together using the WB sign from the OSH notam, or do we need a more specific one (ie, CJ6)?

Reason I ask is that I'll be arriving on the morning ...

Hi All!

I'm looking for an intake manifold drain kit, or at the very least the plug ends that will thread into the manifold itself. I have the stock Housai engine and manifold sections.

I've ta ...

Being Canadian I will refrain from commenting on the political scene in the United States (unless someone wishes to discuss NAFTA) but I do have a few thoughts on fuel prices.

Do I think the curren ...

No real solution found. We pulled apart the water separator (it was a mess and ultimate replaced it), blew out what lines we could access in the engine compartment and ran a bunch of WD-40 through th ...

Hey All!

I've just reinstalled my prop after having it overhauled and repainted. After shutting down from the first run we had a small amount of grease running down each prop blade from the hub ...

If you wouldn't mind, I'd appreciate a copy as well.

Thanks!

Mike Kirk

Hi All!

I'm trying to track down a pair of Trim Tab spindles (Part#HB1-703G), the AN replacement from Aircraft Spruce didn't quite do the trick. I'd also like to replace all the screws with stainl ...

I would love to be there, but the rostering God's have dealt me a loosing hand in May and so I'll be spending 3 fun-filled days in Anchorage on a work trip. On the plus side, AK is a great place for ...

Congratulations!

Looking forward to seeing you and your new birdie at Bandits, Classic Air Rallye and whenever we can escape from our families!

Mike Kirk

Hi All!

I was wondering if anyone has ever used the X-plane flight simulator program with either the YAK or CJ? I've tinkered with it using my current work equipment (A340-300/600) and it's proven ...

I use the Lowrance 2000c and can only say good things about it. The smaller 600c has all the same functions, just a smaller screen, and would also be an excellent buy.

Mike Kirk
C-GYMK

Hi All!

My prop is currently being overhauled and I'm having it stripped and repainted while it's at the shop. As they doesn't stock blue prop paint I was hoping someone might know where I can fin ...

Don't worry Skid.. assuming the Rostering God's smile upon me I'll be going to the clinic as well... I'm sure at least one of our combined GPS' will know which way is right!

Mike K