Matronics Email Lists

Same here. 27 years and 1200+ hours with no regrets.

Marcus

On Sep 25, 2023, at 16:07, Phil Perry <philperry9@gmail.com> wrote:

ï»¿

I have stuck with the standard and ran Dress ...

Iâ€™m slow getting my conditional inspection done this year in part due to no availability of Aeroshell 6 for the prop hub. Does anyone have a source for 14 oz tubes or a good alternative? Everything ...

I just relocated to KAPA, Centennial in Denver, CO. I learned about high altitude takeoffs long ago, but was wondering if anyone has specific techniques for the RV-10 with an IO-540?

Thanks,
Marcu ...

Thanks,
David, I found a Whelen power supply on eBay for a great price yesterday so am going to give that a try.
Lew, Interesting point on powering up after sitting. I take it you connected ...

Those are really neat! Iâ€™m mostly looking for a new power supply, but these may very well be in my future.

Thanks,
Marcus

On Sep 17, 2021, at 17:19, Lenny Iszak <lenard@rapiddecision.c ...

I have a Strobes N More Pro 606 power supply driving my strobe lights and it has been working great, but the power supply connector has become loose after 16 years and is intermittent. I'm not su ...

SureFly sounds like a good option but I now understand it too requires a power supply. I like the simplicity of a magneto as my backup ignition given one electronic ignition provides about 95% of the ...

Yes, Iâ€™ll be needing a magneto with an impulse coupling or a setup that will do the same job of providing a spark at low rpm.

Thanks for the inputs,
Marcus

On Nov 25, 2020, at 6:54 PM, Kelly ...

Thanks Lenny,
On the G3X it doesnâ€™t read my mag anyway as it has different pulses than my electronic ignition so thatâ€™s not really an issue.

In the mechanicâ€™s defense I only posed the q ...

During my run up to fly to meet the family for thanksgiving the left magneto was completely dead. Back to the chicks to troubleshoot where I removed the P leads in case they had grounded somehow with ...

I had a similar experience. After a kickback my initial starter sheared the protective shaft killing the start. I sent it in to upgrade to the high torque starter with kickback reset so that wonâ€™t ...

Thanks again for all of the guidance.

Turns out a 7/16â€ hose works quite well. I should have tried the drill but honestly forgot in the heat of the moment.

My borescope is poor and gave up o ...

Tim,

Thanks again for the info. Unfortunately by work environment is poor at best so Iâ€™m hoping to minimize trips to the airplane. Lazy question, but any chance you recall what size tubing you go ...

Thanks Tim!

As always you are a wealth of helpful information.

Marcus

I have a clear leak in one of my exhaust valves while doing a compression check. The odd thing is I seem to have normal power and the temperatures are all consistent with the other cylinders. Just c ...

Thank for the recommendations to contact Don at Airflow Performance. He was exceptionally helpful and replaced my fuel pump including a small mod to use on my current setup for HALF the price Van's i ...

Sorry for the delay, my account dropped out for some reason. I did talk to Don and he was an immense amount of help.
Thanks,
Marcus