Matronics Email Lists

I'll see if I can dig mine up today, I'll let you know

I currently have a clear filter on each down line and one just before the carb. I have been experiencing unequal flow especially from the left tank it seems to draw down much faster than the right tak ...

I'm right in the middle of changing out all my fuel lines, getting rid of the original factory stuff. Is it over kill or a good idea to have fuel filters from the wing tanks to just before the header ...

Tex, here's a link to where you can buy them. I didn't purchase mine I took them off electrical chargers that I had laying around. I do plan on buying some new though.

http://www.tdk.com/distribut ...

They were TDK 100-150 MHz ferrite beads, snap on. I also put one on the antenna cable near the Icom. Not sure it helped though.

Seems putting a choke on each mag to distributor wire did the trick

Barry, I have the radio powered by its own battery, I also have a power adapter that plugs into the power port in and its supposed to be filtered. The spark plug wires and spark plugs are original ...

Thom, do you have any filters or capacitors installed on your set up?. How are your mags wired? is the mag wire shielding grounded to the engine as I've read about in the achieves.

Thanks

I've been have interference problem with my hand held Icom A24 to the point that is almost useless. I called Jim over at Jabiru Pacific and he informed me that hand held radios can't be used with the ...

Just purchased a tri gear set up for my model IV. Does anybody out there have the install instructions available?? I'd like to get a copy. Want to do it correctly

Items sold, thanks Ed

For Sale:

(1) Falcon Air Speed Indicator Model ASI160M-3, 20-160 MPH, 3 1/8". New In box, purchased 2002 but never installed. Purchase price $114.95, sell for $60.00

(1) Flight Da ...

Lynn, they do go out through the cowl! I wasn't aware that the muffler could be reversed- bummer- cut two big holes in the cowl, thanks for the info.

Here's a few photos taken at Hanford,Ca. airport of the 1st flight on 11/1/09

Here's a few photos taken at Hanford,Ca. airport of the 1st flight on 11/1/09

Sunday, 11/1/09, 11:00 AM N443DM took the air for the first time. All went well with 1/2 hour flight ,all gages in the green, only one minor problem with a slightly heavy right wing. I didn't fly N443 ...

Problem fixed, installed a new Plated steel bushing (sharp threads) applied Permatex 9 AR Tack and Seal. Let it set a few days , no leaks to date. Thanks for all the responses.

Marco, what the brand and product number you used on the threads?

Thanks

thanks Pat, I've tried the liquid yellow type, it worked on all fittings except the bottom one. What's the Brand and product number for the stuff you are talking about?

I may need to change my header tank in my model iv because of a problem leak at the bottom fitting bushing. I think the threads were tapped to deep or I may have tightened to much. My question; is th ...

Thanks Tom, back to the airport on Saturday to try again. I guess the sheet spec's that specify 19 to 20 degrees is a mistake???? Oh yea I have a digital smart level also.