Matronics Email Lists

Thanks Roger.

Could someone please tell me the Torque specs for the M10 Allen bolts from the Ring Mount to the 912 motor? Thanks.

Could someone please tell me the torque value for the Ring mount M10 Allen bolts to the Rotax 912? Thanks.

I just drew the center wire out, cut in vise at slight angle then filed. Then put the center wire in and cut that to length.

Crankshaft off Rotax 912 ULS2, $2500 OBO. Harvey Richards, 902-825-6042.

I used a peice of Z angle either side with the Z down. Tied in nicely.

Congratulations Doug. I have to get moving again with my build.

Thanks Doug. That makes more sense than having both at 90 degrees as the cables have to go to the top of the fuse ans should be equal lengths as I see it.

When setting up the pitch control rod,have you used the length in the plans,685mm which would put the horizontal tail bellcrank at approx 75 degrees when the stick is at 90, or are they both at 90 deg ...

Thanks. I had no luck finding it.

Is there a list of the individual parts and prices online for the 750? Thanks

Jeff is excellent to deal with. I got some parts from him in the past. If you are in the market for these parts you wont be disappointed. Harvey

Beautiful looking plane. Congratulations , Harvey

I seem to remember somewhere I read about changing the mounts on either side of the instrument panel that rivet to the cabin frame. Has anyone here done this? pros and cons. Thanks

The direction to the Blog was to answer the question of wing sweep.

The Blog was under Can-zac and titled Wing Attatch

Mark Townsend did a blog on the Zenith Aero website about fitting the wings. I think it entailed drilling the forward holes for the wing spar then leaving the drill bit in place. The rear posistion wa ...

Sorry I was not very clear on this. I am talking about the location of the firewall in respect to the 2 side skins. Once all the holes are drilled in the side skin at the firewall rivet line it will b ...

Has anyone had any trouble positioning the firewall before fitting the engine mount. The top at the cabin frame and the bottom at the extrusions are set, leaving the two side ones to worry about. I wi ...

Thanks to you both for the reply. I was trying to get it straight but that is not possible. Do not archive.