Author |
Message |
Topic: Icom A6 Power Supply |
JOE RONCO
Replies: 12
Views: 17856
|
Forum: AeroElectric-List Posted: Sat Aug 07, 2010 11:20 am Subject: Icom A6 Power Supply |
The Batteries America CP-11L might be a good way to go for use with 12 Volt plane power. See:
From: owner-aeroelectric-list-server@matronics.com On Behalf Of Robert L. Nuckolls, III
Sent: Sa ... |
Topic: HOSE FOR ROTAX 912 |
JOE RONCO
Replies: 19
Views: 17844
|
Forum: RotaxEngines-List Posted: Sun Jan 31, 2010 1:51 pm Subject: HOSE FOR ROTAX 912 |
LES: I don't know how they would fit as I have not used this hose. I just
did some research on material compatibility with gasohol and found the
SAE/Goodyear products. I guess it would depend if you ... |
Topic: HOSE FOR ROTAX 912 |
JOE RONCO
Replies: 19
Views: 17844
|
Forum: RotaxEngines-List Posted: Sun Jan 31, 2010 11:52 am Subject: HOSE FOR ROTAX 912 |
You should consider SAE30R7 for low pressure especially for gasohol. If the
fuel is pressurized then SAE30R9 is recommended. These can also be used for
oil I believe. See attached Goodyear cut sheet ... |
Topic: Jabiru Flywheel Bolts Important Notice |
JOE RONCO
Replies: 5
Views: 6341
|
Forum: JabiruEngine-List Posted: Wed Nov 04, 2009 9:34 am Subject: Jabiru Flywheel Bolts Important Notice |
FWIW attached is a copy of the draft report on the flywheel bolt breakage by Anton Lawrence with pictures for those interested in seeing what the problem looks like.
Hope this helps.
Joe R
-- |
Topic: Wisdom from Military Manuals, etc. |
JOE RONCO
Replies: 0
Views: 1109
|
Forum: AeroElectric-List Posted: Sat Aug 08, 2009 6:56 am Subject: Wisdom from Military Manuals, etc. |
A little humor since laughter is the best medicine!!!
Wit and Wisdom from Military Manuals, etc.
"A slipping gear could let your M203 grenade launcher fire when you lea ... |
Topic: Battery Chargers and Maintainers |
JOE RONCO
Replies: 2
Views: 1319
|
Forum: AeroElectric-List Posted: Thu Aug 06, 2009 7:48 am Subject: Battery Chargers and Maintainers |
BOB: Just a point of clarification, the Mr. Ronco that you referred to is really Ron Popeil who made a fortune selling the Pocket Fisherman, the Veg-O-Matic and Rotisserie Grill among many others. I w ... |
Topic: Marking Wires? |
JOE RONCO
Replies: 13
Views: 9921
|
Forum: AeroElectric-List Posted: Tue May 19, 2009 9:34 am Subject: Marking Wires? |
A simple and low cost way to mark wires is to use wire number markers (1/4” x 1 ¼”) lengthwise on each end of the wire and then put heat shrink over it. The only down side is that you have ... |
Topic: Fuel Line Growing |
JOE RONCO
Replies: 7
Views: 7681
|
Forum: RotaxEngines-List Posted: Mon May 11, 2009 8:52 am Subject: Fuel Line Growing |
JIM: Goodyear says for SAE30R9 "WARNING: Do not immerse in gasoline". Both 30R7 and 30R9 have the same outer cover (Black Hypalon-see attached Spec Sheets) so maybe the same warning applies ... |
Topic: Price Difference of 91 mogas and 100 LL? |
JOE RONCO
Replies: 3
Views: 3226
|
Forum: RotaxEngines-List Posted: Tue Mar 17, 2009 2:04 pm Subject: Price Difference of 91 mogas and 100 LL? |
You might check the link below.
[url=http://www.airnav.com/fuel/]http://www.airnav.com/fuel/
Hope this helps.
J Joe R
-- |
Topic: 3300A - Full Throttle Roughness |
JOE RONCO
Replies: 40
Views: 26343
|
Forum: JabiruEngine-List Posted: Fri Jan 16, 2009 8:22 am Subject: 3300A - Full Throttle Roughness |
Or you could trade it in for a new UL Power ([url=http://www.ulpower.com]www.ulpower.com) Model UL350i (same or better performance as the 3300) and get EFI/FADEC as standard. No messing with carbureto ... |
Topic: Rotax Engine Technicians |
JOE RONCO
Replies: 13
Views: 9008
|
Forum: RotaxEngines-List Posted: Tue Dec 16, 2008 1:36 pm Subject: Rotax Engine Technicians |
Try:
Roger Lee
Tucson, Az.
Light Sport Repairman - Maintenance Rated Rotax Service Center 520-574-1080
Roger Lee (ssadiver1@yahoo.com (From: owner-rotaxengines-list-server@matron ... |
Topic: breaker specs |
JOE RONCO
Replies: 5
Views: 2840
|
Forum: AeroElectric-List Posted: Wed Dec 03, 2008 9:54 am Subject: breaker specs |
BEVAN: I don’t know if this is what you are looking for but try this link.
From: owner-aeroelectric-list-server@matronics.com On Behalf Of B Tomm
Sent: Tuesday, December 02, 2008 11:3 ... |
Topic: B&C S700-2-11 switch configuration |
JOE RONCO
Replies: 5
Views: 2297
|
Forum: AeroElectric-List Posted: Fri Nov 28, 2008 6:03 pm Subject: B&C S700-2-11 switch configuration |
It looks, from Page 15, that the 2-11 ON-ON-OFF is the same as 2-1 ON-OFF-ON except for the
location of the OFF position and +$12.00. It is similar for the 2-5 and 2-51.
Joe R
F ... |
Topic: B&C S700-2-11 switch configuration |
JOE RONCO
Replies: 5
Views: 2297
|
Forum: AeroElectric-List Posted: Fri Nov 28, 2008 10:46 am Subject: B&C S700-2-11 switch configuration |
BOB: See Page 15 in the B&C catalog.
http://www.bandcspecialty.com/2008_Catalog_20pg_sm.pdf
Joe R
-- |
Topic: Fuse block |
JOE RONCO
Replies: 6
Views: 4296
|
Forum: AeroElectric-List Posted: Mon Oct 20, 2008 2:42 pm Subject: Fuse block |
BOB: You may want to check out the Bussmann 15710 series at
From: owner-aeroelectric-list-server@matronics.com On Behalf Of Bob McArdle
Sent: Monday, October 20, 2008 9:51 AM
To: aeroelec ... |
Topic: Sensenich prop for the 3300 |
JOE RONCO
Replies: 2
Views: 2068
|
Forum: JabiruEngine-List Posted: Sun Oct 19, 2008 9:51 am Subject: Sensenich prop for the 3300 |
You can also check the link below from the Sensenich web site.
From: owner-jabiruengine-list-server@matronics.com On Behalf Of Craig Payne
Sent: Sunday, October 19, 2008 10:53 AM
To: jabir ... |
Topic: Copper buss-bar from copper tubing |
JOE RONCO
Replies: 16
Views: 6963
|
Forum: AeroElectric-List Posted: Mon Oct 06, 2008 11:33 am Subject: Copper buss-bar from copper tubing |
DAVID: Go to http://www.mcmaster.com/ and search for Page 3610. There is a
large selection of copper bar stock.
Joe R
-- |
Topic: ROTAX-OWNERS Site bye-bye |
JOE RONCO
Replies: 5
Views: 4355
|
Forum: RotaxEngines-List Posted: Wed Aug 20, 2008 8:32 am Subject: ROTAX-OWNERS Site bye-bye |
If you try [url=http://www.rotax-owner.com]www.rotax-owner.com I believe this is what you are looking for. No “s” on owner.
Joe R
-- |
Topic: Premium Auto Fuel Ethanol Content for 912's |
JOE RONCO
Replies: 3
Views: 4086
|
Forum: RotaxEngines-List Posted: Sat Aug 16, 2008 12:43 pm Subject: Premium Auto Fuel Ethanol Content for 912's |
Don't know which brand is best but as far as testing for ethanol it is a
little more involved. See EAA Test Kit at:
http://www.eaa.org/autofuel/autogas/test_kit.asp
Joe
-- |
Topic: Rotax Engines-List: 91 octane and time to be heard |
JOE RONCO
Replies: 9
Views: 8125
|
Forum: RotaxEngines-List Posted: Sat Aug 09, 2008 1:31 pm Subject: Rotax Engines-List: 91 octane and time to be heard |
Check out their web site at http://www.swiftenterprises.com/
They are working with FAA, ASTM and engine manufactures (Lycoming in
particular) on getting approval for a non-alcohol renewable fuel t ... |
|