Matronics Email Lists

Patrick.
Send email to jackm@vinetechequipment.com . I will reply with pictures of what we did. Prop cable is also routed above engine and left heat input is on rear right baffle. Prop cable above al ...

Bob,
Rick is dead on. Call Geoff at Aerosport products as he provides the Lord adhesive. If building again, I would use to glue the door halves together as well.

I do not know Tim personally but have been on his website numerous times as I think many of us have. He has created a huge resource for us as builders and someday would like to thank him in person .. ...

Myron,
We just received ours back from paint. As far as wing tips, we had to cut them to length and slit the rear edge apart in order to match to align. Both tips had a tip up and it was impossible o ...

Bill,

Two forklift supports was 3 x 5 x .188" Across rear was 4 x 4 x.188" . Slid in each side was 3.5 x 3.5 x188" tube that was welded to 18" of heavy 8" c chan. Center f ...

This is how we moved to paint shop for four hour drive. Very secure and easy to move. This skid will be available to anyone to use after it returns back.....only problem is it weighs half as much as c ...

Not flying yet but I have gone above engine. two reasons, To go with Show Planes cowl this is a requirement because lower install interferes with induction system, My engine block did not have the two ...

Rick,

I agree with all the above...one thing I would add is when you go to cleco your door skins to the fuse, One,make sure your cabin top is bolted to fuse in place as you would on final install a ...