Matronics Email Lists

John,
My set-up software seemed to run fine. I had, however the issue, that de-
spite uploading the new settings (and then confirmed by downloading the new settings for check), during flight I could ...

DuaneFamly,

I'm absolutely sure that the update-software is not made faulty by intention.
In Europe we have a extremely good support by Airmasters representative.
Unfortunately he has been on a l ...

Trevor,
The controller was not removed from the instrument panel. All cables were
still in place during the update. Everything seemed to work well, until the
update was completed and the power was ...

I was trying to alter the preset rpm by using Airmasters setting program.
I did not give the wanted result, and in turn I asked Airmaster support.
The support guy sent me a new software update for t ...

Oops.
I did not notice, that the altitude is in meter. Now it all make sense.
Thank you.

Regards John

Trying to attach a second file

Dear all,
I'm in progress of flight test of my Europa and have come to speed
performance test. I will need to show the speed for 100%, 75% and 65%
power settings and for various altitudes.
I hav ...

It's so terrible to see all these disasters. Hope you are well and no human
lives has been lost.
Feel almost too safe here in small quiet Denmark. (Except from seeing
what's happening a few hundr ...

Thanks to you Bud, for your reply.
I checked the bolts through the nose leg a while ago, and found the bolts
to be damaged and the holes elongated.
I have enlarged the bolt holes reamed them to mat ...

I have found that the previous owner of my Canadian imported Europa XS
have extended the vertical nose wheel spindle 50 mm and installed a 50 mm spacer.
That means that the nose is lifted 50 mm up ...

It looks like I will need some very good advice from you fellow builders.

I have measured the fixtures and torque tubes on my Europa a few times.
Unfortunately I come to the same result in spite ...

This happens when the connection is not 100% tight. Bad connection creates heat.
John

Hi Jonathan.
The E10 has been on the market (in Denmark)for a couple of years, only.
In our Europa 912S we are using standard fuel RON 95 E10, only.
Have used the RON 100 E5 once, but seems to be w ...

Bud.
Thank you very much for your very thorough explanation.

Regards John

I'm in the process of refurbishing my instrument panel.
Amongst others I'm replacing the com radio. In the old setup a 'Flightcom
403' (intercom) is installed.
According to the manual of my new ra ...

Bud and Barry.
Does it mean, that I can't simply buy and install a used wing for my XS
without having to make serious additional works/alterations on the new wing to make it fit?
Regards John

Thanks.
Karls Europa is now in Denmark. After checking it I found that the wings had been damaged and needed to be repaired. (Wind had been 'repaired' by hiding the severe damage with filler and pain ...

I have purchased C-FIRS which have (had) a yellow panel

Thanks for your advice, Paul.
Will it be possible for you to give me his contact details on a PM.

Dear all.
Will some of you be able to tell me the material specification of the skin of an Europa XS.
A professional workshop will do the repair of the cracks of the skin, but before they go ahead t ...