Author |
Message |
Topic: Avgas Stains |
Lowlead
Replies: 9
Views: 6169
|
Forum: Kitfox-List Posted: Tue Apr 07, 2009 12:02 pm Subject: Re: Avgas Stains |
Of all the things I've tried on my white aerothane, the best results for removing the fuel staining was the Mr Clean Magic Eraser. I've tried everything from Simple Green to Lacquer Thinner. The polyf ... |
Topic: Greenhouse construction |
Lowlead
Replies: 28
Views: 15244
|
Forum: Kitfox-List Posted: Mon Feb 23, 2009 5:29 pm Subject: Re: Greenhouse construction |
Why not use rivnuts? ACS & McMaster both carry them. McMaster carries recessed head versions that sit flush to the mounting surface (butt rib). In most cases you don't need access to the backside, ... |
Topic: Elevator Gap Seal Test Report |
Lowlead
Replies: 56
Views: 39061
|
Forum: Kitfox-List Posted: Sun Feb 01, 2009 11:46 pm Subject: Re: Elevator Gap Seal Test Report |
Thanks Rex (and Lynn)! I wish I could say that it's this consistent along the entire length of the gap, but it's not. The gaps tend to be smaller on the outboard ends due to the way the tightened fabr ... |
Topic: Elevator Gap Seal Test Report |
Lowlead
Replies: 56
Views: 39061
|
Forum: Kitfox-List Posted: Sun Feb 01, 2009 5:01 pm Subject: Re: Elevator Gap Seal Test Report |
I use a 3M 3372 polyurethane surface protection tape applied on both top and bottom of the gap (previous posts shown as >-<). The tape is very tough and stays flexible for years. I recently chan ... |
Topic: EGT Probes |
Lowlead
Replies: 10
Views: 6414
|
Forum: JabiruEngine-List Posted: Thu Sep 18, 2008 7:09 am Subject: Re: EGT Probes |
Just an FYI, Westberg (Westach) makes short tip EGT probes that are about the same price as the ones supplied from GRT . If you haven't used the supplied probes GRT has been real good about returning/ ... |
Topic: Tire Balance |
Lowlead
Replies: 9
Views: 6230
|
Forum: Kitfox-List Posted: Fri Jul 04, 2008 2:52 pm Subject: Re: Tire Balance |
Don't know if you've already tried this, but I've read that if the tire has a red paint dot on it, the dot should be aligned with the valve stem for the best balance.
Here's a quote from Skytreads ... |
|