Matronics Email Lists

I have an Odyssey G2, and V10, not a lot of time on it though... just 40 hours.

Dwight

I'm pretty sure that "nozzle" is the same as in my standard set-up, and it's a fuel pressure pick-off point. Since Van's pulls that closer to the pump on their setup, that should be capped ...

I've tried the hardware-store screw removal bits with marginal success, I've found that just using a standard drill bit run in the opposite direction with some solid pressure frequently gets the screw ...

Is it just the flimsiness of the gray Vans seal that people object to? That's what bothered me, so I went with a AS-acquired seal that was the same dimensions as Vans, but was more of a foam-rubber-l ...

I painted cabin top using paint from a local auto paint supplier. Came out nice. A bit glossier than I wanted, but it was what they recommended and looks nice. Had them color-match the leather and ...

I've got an RV-10 and have an IO540-C4B5 from a working Aztec with the larger mounting ears I understand Rocket's need. I'll trade for the smaller ears I need.

Call me if interested, I need to dec ...

So does all of the above mean the cabin vent air is being exhausted out the doors through the gap? Or are there other significant leak paths?

FWIW, I believe Lycoming stopped making the narrow-deck simply because they wanted a single production line, and the wide-deck had some other advantage relative to the product line they offer, I forge ...

Just don't plan your trip around the Shuttle launch- Nov is a long ways away and slips in schedule are fairly common.

Dwight

Don't forget it's 100 (or 150) lbs times the maximum g-load under flight conditions that the structure has to support.

Dwight

Nice Larry!

What's the thicker padded section for on the tunnel in front of the fuel switch? Knee padding?

Dwight

I used a regular old Dell laptop hooked up to a NavAero tPad800 in my Turbo Arrow for several years. Nice low cost solution. tPad is small enough to yoke-mount, but had 800x600 resolution. Down-side ...

I'll add to Carl's excellent write-up that I did a little filing of the elevator horn skins on mine to get a better gap. Was not much though. I did measure more than just the end gap locations thoug ...

Just to pipe in, my steps also had the pre-drilled hole, also were off by the same amount, I also called and talked to tech support, who also acted surprised and gave me the same response. At least t ...