Matronics Email Lists

This is an interesting topic, and one that I expect will get more coverage as RV-10s continue to compete with SR22s.

Iâ€™m building an RV-10 and currently fly a Cirrus SR20, as well as three spa ...

I used either the EAA or AOPA templates (they are similar) to buy a Cirrus for a flying club and later to buy a complete RV-10 kit (including engine, prop, avionics, etc.) for myself. In both cases, I ...

Werner, the cabling bracket called out in OP-37 is F-10111 (L or R) and it is only long enough for two left brackets and two right brackets.

Unfortunately, I donâ€™t know what part you have pict ...

I just tried an AN5 nut on the stud that connects my aluminum tube to my Planearound pin. It fit perfectly, with no drag.

Perhaps your threads were damaged or contaminated? You could try running a ...

Werner,

I believe the threads you are asking about are specified in Step 1 on page 45-14 - 5/16" x 24 threads per inch.

Tom

Here is a link to the RV-10 flap motor retrofit kit. From: <owner-rv10-list-server@matronics.com> on behalf of Tim Olson <Tim@MyRV10.com>
Reply-To: "rv10-list@matronics.com" &l ...

David,

How did you seal the hatches? Did you follow the instructions or use some other preferred method?

Thanks,

Tom

I installed the Van's yaw damper kit for Skyview ($160), which does not come with the tiller arm/bow (Garmin may call it a hoop) that connects the rudder cables to the servo. That is another $160 from ...

From Lycoming Service Instruction No. 1275C "Cleaning Fuel Injector Nozzles":

In normally aspirated engines where the nozzles, P/N LWÂ18265 (see Figure 2), are installed horizontally, ...