Matronics Email Lists

I had the same question last year when I was using Alodine coated ALCAD for a bus bar. I talked with the manufacturing tech. staff and got the following reply...I also included another comment. I n ...

I also am interfacing a panel mount 560 with my avionics (PMS6000B audio panel). I use their bare wires cable 010-11385-03.

Your questions:
Does this strategy and resistor value sound right ...

If soldering is not necessary, Could a strip of Aluminum be used for the bus bar?

What are the disadvantages in using the B&C S701-1Continuous Duty Contactor in place of the S702-1intermittant duty starter contactor, in a engine start application?

I'm installing a Garmin GTX-327 Transponder and will need a coax cable with a 15 foot run to its antenna. According to the GTX-327 install. manual, a double shielded 50 ohm coax cable with less than ...

I'm trying to adapt my ICOM A23 (NAV/COM) hand held xcvr to my panel also. The A23 is very similar to your A6 electrically. I ordered a BP-200, battery eliminator (it replaces its battery) and conne ...

I'm building an RV-9A with an Eggenfellner Subaru E6 engine. I will be mounting my batteries in the tailcone of the AC, and will have to route the power cables (probably two #6 wire size with termina ...