Matronics Email Lists

It's a shame that Garmin is so short sighted. Success has gone to their heads. Word of mouth is effective advertising good or bad. I have had very good service from Dynon. I cannot say the same for Ga ...

http://www.digikey.com/catalog/en/partgroup/en3-series/2186

switchcraft en series is sealed, small and works well for trim cables. It takes reasonable soldering skill but not bad.

Ralph

OC asked about the simple procedure for AMP crimp QA.
Their PIDG crimpers have a witness mark in the die that is visible in a crimp. It at least allows you to know that the proper crimper was used. T ...

[quote="retasker(at)optonline.net"]Here is the schematic for the Ray Allen indicator. As shipped it uses a 5k pot. Since the wiper of the pot drives a high impedance op amp node you could j ...

OC,
If you have the ray Allen potentiometer measure it with an ohm meter and see if it 10k total. If so it will work. There is not enough info published on the Ray Allen to tell but a simple way to c ...

If the switches are in a row or several rows drill a plate to go behind the panel as thick as the tang on the anti turn washer. In this plate punch the index holes in the correct location. This is the ...

Altronix makes a number of Power Supply chargers of various capacities. Look for AL400ULXB for a board only solution. They also have the same supply housed in a steel cabinet. These are designed for t ...

I used a USB socket designed for one of the card slots in a PC. It takes a small rectangular hole and two screw holes in the panel. This is powered by a 12vdc to 5 vdc switcher Mean Well from Mouser. ...

I'm looking into the purchase of a video Borescope. (Cylinder and general inspection) Does anyone on the list have direct experience with any of the lower cost devices <$500?
Thanks.

Ralph Hoov ...

Glen,
You didn't say if it ever worked. From the symptoms you present it would appear to be the mic audio connection from the audio panel to the to the 530.

Other com working says the mic and audi ...

It’s time to turn our beautiful flying RV7A into a beautiful looking RV as well. Builder reports on east coast paint shops would be appreciated.

Ralph & Laura Hoover
RV7A N527LR ...