Matronics Email Lists

As I mentioned earlier, I have had my fair share of electrical issues. It appears that this noise is the result of or partially caused by low voltage directly related to another electrical problem.
...

No I have not hooked up the T/C to a seperate power supply. I'll try that as soon as I can and report back.

I tried the capacitor and it didn't make any difference. I went ahead and filled out the order for the filter and I'll give that a try.

In response to the question about the intercom....the headse ...

The noise is there always, regardless of transmitting or receiving. I can put my headset on, turn on the master, listen to the gyro spin up in the headset, then turn on the landing the light, and the ...

I have had a good deal of electrical issues from strobe noise, to bad crimps that burned up wires. I have slowly but surely resolved alot of the issues. Recently I installed an LED landing light. Duri ...

I recently fitted an LED driving light into my wingtip. I am now interested in making it flash so I am more visible in the pattern. What is the best/cheapest way of doing this? I have seen the Wig Wag ...

Thanks Bob for the info.

I checked Radio Shack and found this CB mount.

http://www.radioshack.com/product/index.jsp?productId=2102429

It looks like the one in your DIY article. If my thinkin ...

I am not sure if its metal or not. I am not near the plane and was wondering if anyone knew. I was trying to get my gameplan down before I go back to the hangar an hour away. This also got me to think ...

I have a DM C63-1 antenna that I need to relocate on my kitfox. It is inside the fuselage (done by another builder) and it will not transmit since it is basically in a cage of tubing. My fuselage has ...

I had originally posted this message on the Kitfox Forum and have since spoken to Bob on the phone and he suggested that I put this on the aero electrical forum as well. I believe that it was a bad co ...

From the Warp Drive Website: http://www.warpdriveinc.com/faq.html

What is blade tracking and what is the approved tracking tolerance?

1/2 an inch is acceptable. Make sure the blades are al ...

I ran into the same problem with the Purolator being to tall. I went with the Napa Gold.