Matronics Email Lists

While reading the upholstery link, Juan mentioned that as long as the engine and prop are balanced vibration should be minimized.
I installed my prop last night and will be doing engine starts so ...

Can anyone tell me what size rivet sets to order for the 601upgrade? I need to know so I can order some from acs to practice on. I have ordered my upgrade kit but as a non AMD and non flying C I t ...

I am trying to find a diagram of how to connect a Mc5 master with a mc-4 slave. The slave has two holes but the master only has one.
Can someone expain or show picture of correct connections?
I ...

Can anyone tell me the range for the oil temp and oil pressure sensors on the jab 3300.

oil pressure oil temperature
o psi= ? ohms any deg f = ? ohms
20 psi= ? ohms any deg f = ? ohms ...

I have an acs0714 microchip that reads up to 20 amps and connects to a micro-controller. I am at a total loss on where to hook this thing up.

I want it to operate like the old style amp meters. L ...

order 20, thanx a bunch

Adel clamps, Aircraft spruce?

I want to install the torque tube for the flaps but the instructions show matching the hinge up to the center of rotation on the tube.
Can I use the wing mounting bracket as a reference for the t ...

Thanx for the info guys. I have decided to continue using the zinc chromate and rivet the plane before putting the engine on.

I drilled my last holes today and will begin disassembly tomorrow fo ...

I purchased a kit that the owner had done the 2 day build seminar with. Consequently, the rudder and elevator were complete when I purchased the kit.
The elevator trim motor has no holes to run th ...

I am curious how I can buy a plane that is "A few hours from air worthiness inspection." Doesn't the 51% rule come into effect?
I don't want to seem rude, I really am curious on how to d ...

Glad to hear that zc is still the way to go.
Next question is , Can I put the engine on and run it with the airplane in clecoes?

Long time reader C rare contributor to discussions as I don't know anything.
I seem to remember reading a post about an inspector who said zinc chromatic is neither desirable nor required. I was ...

Thanx, that will save me a bunch of grief.

Hmm, hall efffect not supplied? What is that a $2 transistor. I saw a pic with the sensor installed on a Jab site. I ass-u-me-d that it was supplied.
I assume there is a mount for it on the engine? ...

I am trying to connect my aircraft to a microcontroller and some adc's.

Will a hall effect rpm sensor work on 5vdc?
Are the oil temp and oil pressure sensors just pots like the fuel level?

I am ...

I am trying to find explanations on the sensors for the 3300. Specifically the electrical characteristics?

I am trying to wire them up to a microcontroller and some adcs.

Rpm--- will the hall ...

Can anyone suggest a good right angle drill for the top skins? I found one from grainger $130 and one at aircraftspruce a little more expensive.
Local Grainger doesn't have it in stock and I don't ...

I am looking for a way to mark my wires in my Zodiac 601XL. I am just finishing up the body and will begin engine installation soon.

Can anyone suggest a method to print on shrink sleeving if po ...

i expected a wait time of 3-4 months. I was told I could have the engine end of Dec if needed but better end of Jan. I expect to get the engine end of Jan but I am really not ready for it yet.
Don