Matronics Email Lists

I have been building up my 4WD Tow vehicle with auxilliary batteries, solar panels etc, and was wondering if its viable to transfer some of my new found experience to my experimental aircraft .
I ha ...

Hello Electrical Gurus.
I recently got an email from Aircraft Spruce advertising Appeareo stratus dual power usb charging port which was TSO’d.
I am aware that TSO defines technical standards to ...

WE had a similar problem with noise, and the issue turned out to be the
Condensers in the Magneto.
This was despite the Mag having been overhauled about 170 hours prior to
that.

Mick

--

Ok, so I am going blind, or early onset of stupidity, but for the life of me I cannot find which drawing has the hardware callout for attaching the F790 bell crank
to the elevator horns.
Can ...

Howdy, I have put my RV9A on hold while I spend a year or two working as a volunteer in Tanzania.
My wife and I are heading for some R and R in Capetown.
Any Rv builders near Capetown that are inte ...

Greetings O Electronic whizzpersons,
I know this is probably a long shot, but here goes.
I have a Collins 650 ADF and antenna in my possession, but no Indicator.
Simple I hear you say, buy an IND-6 ...

I have seen a number of solutions to tying together the front and rear baffles underneath the cylinders on an o_320,
One solution is to attach springs. That's good, but no one seems to have any idea ...

Howdy Folks,
Mick Muller here, RV9A builder in Australia.
I am looking to get a Panel cut.
I have been trying to contact Fabian at Affordable Panels,
but the email address given on the web ...

"Ralph E. Capen" SAID

Chris,

. I was told that the engine
should not be attached as the road bounces would cause damage.
Ralph

Wow, all that bouncing around taxiing on rough st ...

Thanks Jim, its neither of those two - its the L60 belt driven alternator
that replaces the standard Auto alternator from the front of the engine..
I also have installed the SD-8 as a backup on the ...

Howdy All,
I recently bought a B & C alternator for my RV and am installing it to
replace the ole internally regulated automotive one. The old Auto type
alternator
required some fancy coolin ...

I posted two days ago about problems with cracks in the HS on Rv's. I am
now aware of an RV6 and an RV6A that both have cracks in the corner of the
HS just inboard of the first rib. The crack i ...

Howdy All,

I heard a rumour that Vans has an issue with cracks in the front spar
of the Horizontal stabiliser on the RV6. It seems that the area just above
the
attach point at the front where ...

Hello Electric buffs. I have a question that may appear stupid, but I'll
take my chances.
Below is a statement made by a lister recently:

Subject: Re: Battery problem

Other batteries work too ...

Can you not reach the screw behind the filler tube with an offset
screwdriver?
JimC
Unless its a different kind of screwdriver, no. the offset would have to be about 40 degrees, which makes it dif ...