Matronics Email Lists

Insight TAS 1000
[quote] ---

I would start with trying to shield the plug wires first, also you should have shielded p lead wires goign to your switch grounding the shield at both ends. also check that your antenna base is wel ...

I have no experience with the dynon other than I want my friend to put one
in his rv7. But I can tell you that in installations such as this and like
the G1000, its easier to certify devices in th ...

What?

The code that the encoding altimiter sends out is the altitude when you set
the alitimiter to 29.92, thats called pressure altitude. No matter where
you set the altimeter, the encoder p ...

Install 1 CI 121 on the upper fuselage, and a CI 122 on the bottom. Feed them with rg142 or rg400.

---

Put a 510 ohm resistor inline with each input before it gets to the back of
the audio panel on the ones you will be paralelling together.

device 1 - 510 ohm- \
...

S-Tec sold that compass system to PSI [url=http://www.pacificsouthwestinstruments.com/]http://www.pacificsouthwestinstruments.com/
From an avionics guy point of view, It is a horrible system and r ...

How is your mic audio in the sidetone? Is It scratchy? Could be a dirty mic jack or plug on the headset cable.
[quote] ---

I just did a pitot-static inspection on a new g100 cessna 172 yesterday and
there were leaks everywhere.... check the pipe thread segment of your
connections that go into the instrument for what i ...

If you hook it up to your power source (bus, with a 1A fuse holder just to
protect it) make sure that the kt76 is wired for 14v lighting. I know that
these units run off 14V and work through a dr ...

When Mr. FAA man comes and signs my paperwork, I am certifying that I have installed the device PER THE MANUAL; and the manual says I need to install a certain length of coax with a certain value of ...

You have not had a WAAS 430 for 4 years thank you... That is what we are talking about here and that is where the long coax is mentioned.

Do not archive
[quote] ---

If you need a short cable run, install a 3db attenuator inline and make the cable as short as you want. Otherwise you can excpect to burn up the front end of the gps reciever due to overload, a $900 ...

Encoding altimeters are VERY EXPENSIVE to maintain as a altimeter/encoder system. It is much cheaper in the long run to keep these separate. Call up Kelley Instruments and ask how much an overhual ...

there is a cal to 150 degrees option in the setup mode
this is best done at full voltage(engine running)

Charles Reiche
[quote] ---

As impossible as it sounds I once installed a noise free wx-1000+ system into a glassair that was already well thought out and had a single point ground very close to the battery negative lead. Try ...

Just like when you transmit on one of your com transmitters and your GPS goverage gets knocked out... you need a notch filter on something but alot of times its the ELT, pop a gps freq notch filter ...

This is not the test of an "active" antenna, that being really one that tranmits RF, like com antennas, active traffic (tcas, skywatch) and transponder antennas.... also satcom ( as far fr ...

Insert the typical, "Used once, never opened, small stain" parachute joke here.
[quote] ---

You can prime it but I would spot face the holes where they pass thru the
doubler on both sides and on the external skin from the inside, use the cork
gasket. Comant wouldnt include it if they did ...