Matronics Email Lists

Thanks Alan, that's just what I've been looking for.

It has to energise the starter relay of course,

Steve.

Brilliant ! I had trouble watching the screen I was laughing so much !

Absolutly Brilliant !

Hi Tim,

Mine was an XS, It did it from day 1.

Forgot to mention you need to Redux the AN fittings to the filler neck as you screw then in.

Steve.

Hi Roger,

I had the same problem with my Europa - brown fuel stains from the roof fuel tank vent all the way to the tail plane, this happens with full fuel to the
filler cap on the climb out.

...

Hi Richard,

Try:

Mr. Peter Wilks
Newgate Simms Ltd.
P.O. Box 32
Unit 6, Broughton Mills Rd.
Bretton, Chester CH4 0EJ
Tel: +44-124-466-0771
Fax: +44-124-466-1220
E-mail: peter@newgatesimms ...

Ian, thanks for the quick response,

Steve.

Hi,
can someone with a flying or compleated Europa give me the dimension from the back of the
control stick to vertical front of the seat unit when the stick is fully aft and also stick fully forwa ...

Thats nice to know Graeme, what happened then ? nobody hurt was there ?

Steve.

You can fly it without the spinner temporarily, it does'nt make a lot
of difference,
Steve, No. 630

Ok, it looks like it's not possible
without major modification and even
then it will need intense set up,

thanks,
Steve #630

Can anyone answer as to weather the standard Europa factory wing fitted stall warner
could be connected instead as an AoA indicator? Eg. to the AoA pneumatic
input of one of the Efis systems,

...

Will,
I had to put mine under the port headrest due to the length of the sender unit - it would not fit between the headrests.
however, where I've put it - next to the port headrest access hole, it ...

Hello William,
I am also in the process of fitting the wema gauge in my fuel tank on a new buid - it also will be accessed later through the port headrest.
I don't know what you've ordered from las ...

Robert,
I'm thinking of using those vents also,
Those pictures are a lot more use than the info. On the spruce website.
they look fixed or does the inside rotate to direct air in any direction ?
...

Hi Frans,
when I built Europa No. 573, I coated the friction washer and slot with graphite grease after
noticing that the trim motor appeared to stick/strain when moving, it did not make a huge dif ...

Thanks for the feedback, I'll keep the gasket then.

I've spoken to Light Aero , and they say that this is resistant to
Mogas http://www.lasaero.com/site/products/article?id=D02VK9NTH ,

I'll ...

Hi All,

What about the Gasket ?, I'm thinking of scrapping it and using one of those
sealants to bond the flange directly to the top of the fuel tank - did any of
you scrap the gaskets ?

Ste ...

Hi,
I've cut out the fuel tank for the factory Werner fuel gauge,
it comes with a rubber gasket but I'm not happy with it sealing around the
five AN bolts, what can be used as a sealant for the g ...

Graham,
I let my license lapse in 2010, ( kids, wife, spending too much money on
myself Etc.) I revalidated 6 Months later - I couldn't stand it any more &
I was missing my Europa more & ...