Matronics Email Lists

thank you....I will try this today....

Its interesting because looking back at historic posts there is quite a lot about this issue but nobody has really answered the question (accept you)

I gu ...

I have read a lot about this but cannot find the answer I need.

The CSU arm (without stops) can turn about 250 deg and the manual says it should be set up to tern 160 deg. (The MTV website says 90 ...

The 'Guts ' of that secondary oil tank fell to bits on me ...opened up the casing to re weld but found what look like a couple of 'Funnels' ...(Thats what the welder described to me over the phone)
...

Can somebody please send me a weight and balance sheet for a YAK 50. or has anybody worked out a W and B graph or other format.

plenty on 52 but can't find anything on the 50,,,anywhere or ...

Thanks for all the good advise...I have sent Dennis a PM....Im sure I will get there..eventually..
cheers

ken

Portugal

Thanks Phil....That leak detector is very interesting...but I see they tend to pick up a certain frequency 46khz I think, given out by a little transmitter...so im not sure which type to get...would ...

My air goes from 6 to 4 in one day but I cannot find out where...changed pop off and the two OUT valves...Main Air tap is OFF...but it still leaks..drives me nuts...sprayed a whole can of soapy everyw ...

I had the same problem and then found the rubber seal in the Oil filter (having cleaned it during an oil change) had stretched and didnt seal properly..nipped down the hardware shop and got some 1mm r ...

Anybody know where I can buy.

Non Return valce crush washers and O ring.. ( the Non return valve from the main external point to the Air Tank .

A new Air tank....seems impossible to obtain....ma ...

Thanks guys....excellent and I did all that and found that one of the non return valves was leaky...

stripped it and found one of the crush Ali washers was broken....but how to get a replacement ?? ...

Thanks guys....excellent and I did all that and found that one of the non return valves was leaky...

stripped it and found one of the crush Ali washers was broken....but how to get a replacement ?? ...

why would temperature effect it ?....looking at the diagram it seems it can only go back to the charging point (which its not) or leak around the tank itself (cant see any soapy leaks) or lose someth ...

No flaps ..l yak 50😫

Oh..that's straight forward..thanks....

Is there any way to let the air out without putting the brake on and a thousand times ??

Cheers

How can I drop my pressure from 65 down to a more relaxed 50.
I also feel scared of the high pressure ...prefer to be lower...can I just ad washers to the relieve valve and if so any particular type ...

Well....I have only changed the top ( pressure release) valve....

Are there more and where are they ?? I see a straight pipe going down and maybe there are two either side of the cluster. ....is t ...

Can anybody tell me what might be the procedure to find a very small air leak from the main system...it goes down from 6 to 5 over 48 hours...I can't hear any leaks and have sprayed liquid on most ju ...

A number of us flying YAK 50's and 52's on Russian RA registers( in Europe) have been advised that we can no longer stay on such and I was wondering what other owner/operators are doing about this an ...

I need to contact JILL to buy a rebuild kit but having trouble due to my useless IT ability..keep sending emails to myself....
Jill please advise your contact details so I can order .

Thank you
...

Group,

I have the tail strut seal kit in stock. I also stock the Yak 50 MLG
actuator seal kits. Years ago, we manufactured a batch of stainless
tailwheel cylinders for the Yak 50. We haven't h ...