Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

drain holes

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Kitfox-List
View previous topic :: View next topic  
Author Message
gvjantzi(at)yahoo.com
Guest





PostPosted: Thu May 31, 2007 5:12 pm    Post subject: drain holes Reply with quote

building kitfox model 5 can some one give me some input re drain holes in the rudder thanks Gerry
[quote][b]


- The Matronics Kitfox-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List
Back to top
smokey_bear_40220(at)yaho
Guest





PostPosted: Thu May 31, 2007 6:31 pm    Post subject: drain holes Reply with quote

Hi Gerry,

Just the rudder? OK, I put one on each side at the
lowest point of the rudder at the front post to drain
both sides of the tube. I used the float plane
grommets over the holes opening aft and a little bit
down to suck any water out.

For a tail dragger parked, I added 2 more at the
lowest point along the aft part of the rudder before
it curves up.

If you have ribs that the fabric attaches to, you need
at least one on the lowest point above each rib as
well.

I seem to remember buying 50 seaplane grommets and
being a few short for the whole plane. 17 on the
fuselage belly alone. It takes a lot, but the only
thing you should notice in the end is no rust.

I used the hot point of a pencil soldering iron and
only burned thru where I had 2 layers of fabric, or
more.

Kurt S.
S-5/NSI turbo
Florida and Panama

--- Gerald Jantzi <gvjantzi(at)yahoo.com> wrote:

Quote:
building kitfox model 5 can some one give me some
input re drain holes in the rudder thanks Gerry



Yahoo! oneSearch: Finally, mobile search
that gives answers, not web links.
http://mobile.yahoo.com/mobileweb/onesearch?refer=1ONXIC


- The Matronics Kitfox-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Kitfox-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group