willie.harrison(at)tinyon
Guest
|
 Posted: Mon Jun 25, 2007 2:13 am Post subject: Article on flutter |
 |
|
Dear All
There was an enlightening article on flutter in June's edition of
Flyer Magazine.I was unable to get a legible scan of it to attach to
this but I have asked the editor if they can give me an electronic
file of the article so it can be distributed on this forum. In the
meantime, you might like to search out a copy of the magazine (I
stole mine from the dentist's waiting room this morning...). The
article echoed many of the issues we have discussed (slop, mass
balance, etc) but also makes some other interesting points, including
the behaviour and consequences of disconnected trim tabs.
By the way, on the subject of Loctite, presumably any benefit it
could offer would depend on where the TP12 is in its freeplay range
when the Loctite sets. If the slop is already bad enough that the pip
pin is sharing the torsional loads and the TP12 is Loctited at one
extreme of its range of movement then would that not continue to
stress the TP6 bond?
Willie
| | - The Matronics Europa-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
