Matronics Email Lists :: View topic - wiring restive fuel sender/s

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

wiring restive fuel sender/s

Matronics Email Lists Forum Index -> RV10-List

View previous topic :: View next topic

Author Message

Deems Davis

Joined: 09 Jan 2006
Posts: 925

Posted: Fri May 30, 2008 8:37 pm Post subject: wiring restive fuel sender/s

I'm electron challenged, and so the simplest things elude me at times. 

My question is how to wire the resistance fuel senders. I have 2 wires 

coming from my EIU for each tank. In the center of the fuel sender is a 

screw for a terminal. I assume this is for the sending / signal line, 

there are no other provisions on the sender for additional terminals, is 

it assumed that the unit is grounded through the airframe? In which case 

the 'other' / ground wire/s from the EIU can be terminated at a 

ground/block or on the airframe? If not,  where do it connect the other 

wire/s from the  EIU?



 Deems Davis # 406

'Its all done....Its just not put together'

http://deemsrv10.com/

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

VHMUM(at)bigpond.com
Guest

Posted: Sat May 31, 2008 1:54 am Post subject: wiring restive fuel sender/s

Deems sounds the same as the temp probe one wire to probe and one wire to 

ground.



Chris

---

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

speckter(at)comcast.net
Guest

Posted: Sat May 31, 2008 5:21 am Post subject: wiring restive fuel sender/s

I put a line on one of the screws that hold the sender into the tank.  I was

not sure that the proseal would conduct as well as it should through the

joint of sender and tank.  If you have a good ground at the sender, then you

can connect the other line near by to airframe ground.  That has worked well

on mine.



Gary

40274



--

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV10-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum