Matt Dralle
Site Admin
Joined: 08 Nov 2005
Posts: 25203
Location: Livermore CA USA
|
 Posted: Sat Aug 23, 2008 3:53 pm Post subject: Elevator Skin Trailing Edge Bowing... |
 |
|
Dear Listers,
Backing into the garage today I noticed the elevator skin bowing at
the trailing edge in the review mirror because of the way the light
was hitting it. Basically what the deal is I think is that I bent
the trailing edge of the elevators more than necessary. So, when I
pulled the leading edge apart to fit it over the spar, I now have a
concave bowing effect between some of the bays. Van's goes to great
lengths in the manual to make sure that bend the elevator trailing
edges *enough*, but doesn't make mention of what is "too much". The
radius of the trailing edge is still within spec and there is no
cracking or stress marks. Its just bent too much and looks like of
stupid. Somehow, I did the rudder perfectly, but both elevators
suffer from the effect. I've included some pictures below.
What the common thought on this issue? Are the safety/flutter issues
with over-bending as I have done? What to do...?
Thanks!
Matt Dralle
RV-8 #82880
RV-8 Fuse/Wing QB Kit Delivery Next Week! (Ordered May 20 2008)
| | - The Matronics RV8-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV8-List |
|
| Description: |
|
| Filesize: |
92.39 KB |
| Viewed: |
215 Time(s) |
|
| Description: |
|
| Filesize: |
88.98 KB |
| Viewed: |
203 Time(s) |
|
| Description: |
|
| Filesize: |
75.74 KB |
| Viewed: |
210 Time(s) |
|
_________________
Matt Dralle
Matronics Email List Administrator |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
