 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
dlm46007(at)cox.net
Guest
|
 Posted: Sat Dec 26, 2009 10:14 am Post subject: GRT EIS probes |
 |
|
Anyone getting flaky readings with the GRT EIS EGT probes? My number 4 failed at 200 hours (split in two inside the exhaust); reading was bouncing between 900 and 1100 degrees F. GRT replaced and that probe is OK but now EGT number 6 probe is bouncing between 500 and 700. GRT has sent another "higher quality/temperature" probe and I am about to install for number 6. In all my previous dealing with EGT and TIT probes they lasted 1000+ hours and were rated to about 1600 F. I am going to try the latest GRT probe and then start looking for an Alcore or GEM probe to replace all the GRT probes. CHT probes seem adequate, but EGTs fail early. My EGT probes are 2 - 2 1/2 inches below exhaust port. when working during cruise they always read between 1360 and 1410. During leaning they may reach 1430 for short periods of time (seconds).
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
| Description: |
|
| Filesize: |
28.24 KB |
| Viewed: |
587 Time(s) |
|
|
|
| Back to top |
|
 |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
