Matronics Email Lists :: View topic - Mk3 throttle cable routing

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Mk3 throttle cable routing

Matronics Email Lists Forum Index -> Kolb-List

View previous topic :: View next topic

Author Message

capt_riney(at)yahoo.com
Guest

Posted: Wed Sep 08, 2010 12:41 pm Post subject: Mk3 throttle cable routing

I'm trying to figure out how to run my throttle cables on my 582.  I'm using CPS cables and 3-to-1 splitter.  I'm thinking of mounting the splitter to a plate on the mag end of the engine (on the carb side) where there are a couple of unused inserts.  From there would route the cable down the back of the cage through the fabric and then forward under the fuel tank to the throttle. My cage is covered 1/2 way up with the top of the covering level with the fuel tank, and I'm trying to minimize the number of holes I put in the covering.  Curious as to what some others have done. 



Mark Rinehart

Indy Mark3

- The Matronics Kolb-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kolb-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Kolb-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum