Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Engine Electromagnetic Noise

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RotaxEngines-List
View previous topic :: View next topic  
Author Message
JohnF



Joined: 13 May 2010
Posts: 124

PostPosted: Tue Jul 12, 2011 8:09 am    Post subject: Engine Electromagnetic Noise Reply with quote

RV-12 w/ Rotax 921ULS operating normally. At lower rpm no abnormal noice in the headset. Upon takeoff lots of noise...crackling, spitting, arcing type noise. Radio turned off makes no difference, so it seems to be some radiation getting directly into the Zulu headset, perhaps via the intercom which is yet to be fully explored.

When reducing throttle the noise disappears...its only at higher rpms.

Have you encountered this? If so, what resolution was found? I can fly the plane and just put up with the noise which isn't all that terrible, but want to clear it up. No electrical oddities have been noted.

Thanks for any tips.

JohnF
[quote][b]


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
View user's profile Send private message Send e-mail
l_luv2_fly(at)yahoo.com
Guest





PostPosted: Tue Jul 12, 2011 12:55 pm    Post subject: Engine Electromagnetic Noise Reply with quote

John,
I have a similar issue come up in the last 10 days on my 914. I have an Airmaster CS propeller so for me the spitting / crackling noises occur at lower power settings.
At this point I am getting it through my SL30 radio. At its least troublesome it will break the squelch, at its worst I can hardly hear other transmissions.
My trouble shooting has been focused on eliminating other potential sources. I have ruled out the following:

- Headsets
- Transponder
- Strobe
- Apollo GX50 GPS
- Does not reduce when running on a single mag.

Paul

[quote][b]


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
blackmore(at)platinum.ca
Guest





PostPosted: Tue Jul 12, 2011 5:22 pm    Post subject: Engine Electromagnetic Noise Reply with quote



- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
joeing701(at)simnet.is
Guest





PostPosted: Tue Jul 12, 2011 11:32 pm    Post subject: Engine Electromagnetic Noise Reply with quote

Hello John.

Your Zulu headset has a noise activated microphone, so it could be picking up the sound in your cockpit at high rpm. It should have an adjustment screw to lower the sensitivity.
Check with Lightspeed for this problem. Sometimes it is just the squelch setting in the intercom that you can adjust for this problem. Hope this helps.

Johann
----- Upprunalegt skeyti -----
Frá: "John Fasching" <n29cx(at)ridgeviewtel.us>
Til: rotaxengines-list(at)matronics.com
Sent: Þriðjudagur, 12. júlí, 2011 16:07:12 GMT +00:00 Monrovia
Efni: Engine Electromagnetic Noise
RV-12 w/ Rotax 921ULS operating normally. At lower rpm no abnormal noice in the headset. Upon takeoff lots of noise...crackling, spitting, arcing type noise. Radio turned off makes no difference, so it seems to be some radiation getting directly into the Zulu headset, perhaps via the intercom which is yet to be fully explored.
 
When reducing throttle the noise disappears...its only at higher rpms.
 
Have you encountered this? If so, what resolution was found? I can fly the plane and just put up with the noise which isn't all that terrible, but want to clear it up. No electrical oddities have been noted.
 
Thanks for any tips.
 


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
JohnF



Joined: 13 May 2010
Posts: 124

PostPosted: Wed Jul 13, 2011 7:09 am    Post subject: Engine Electromagnetic Noise Reply with quote

Johann - you hit it on the head ! I flew this morning with a non-noise
reducing headset and there was no noise. I changed to Zulu ANR, fiddled with
the squelch on the intercom, sensitivity on the ANR and problem gone !
Thanks for the help !!!

JohnF
---


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
View user's profile Send private message Send e-mail
joeing701(at)simnet.is
Guest





PostPosted: Wed Jul 13, 2011 8:48 am    Post subject: Engine Electromagnetic Noise Reply with quote

Hello John.

Glad I could help. I like the Lightspeed headsets. Makes all the difference with the ANR.

Best regards,
Johann G.
Iceland.

----- Upprunalegt skeyti -----
Frá: "John Fasching" <n29cx(at)ridgeviewtel.us>
Til: rotaxengines-list(at)matronics.com
Sent: Miðvikudagur, 13. júlí, 2011 15:05:30 GMT +00:00 Monrovia
Efni: Re: Engine Electromagnetic Noise



Johann - you hit it on the head ! I flew this morning with a non-noise
reducing headset and there was no noise. I changed to Zulu ANR, fiddled with
the squelch on the intercom, sensitivity on the ANR and problem gone !
Thanks for the help !!!

JohnF
---


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RotaxEngines-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group