Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Wednesday DOTH

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Europa-List
View previous topic :: View next topic  
Author Message
riddon(at)sent.com
Guest
PostPosted: Mon May 29, 2006 11:20 pm    Post subject: Wednesday DOTH Reply with quote
Anyone up for a DOTH on Wednesday?

I am only just back from my travels and have not been keeping up with
where DOTH'ers have been to recently so I would like to leave the choice
of venue to someone else.

Richard Iddon G-RIXS

- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
ptag.dev(at)tiscali.co.uk
Guest
PostPosted: Tue May 30, 2006 12:36 am    Post subject: Wednesday DOTH Reply with quote
Hi! Richard Welcome back !
I would have enjoyed meeting up except G-PTAG nose wheel fell off on
landing back from Shobdon Sunday evening ....Prop write off and nose leg
went "pot holing" and was ripped off, so major reworks needed, sorry!
No injuries though inspite of a "greaser" so we must be thankful !

Just on passing I suggest everyone checks the integrity of the roll pin
which secures the nose wheel pivot shaft to the wheel styrup since when
you adjust the "shimmy" friction you are tightening against a damn roll
pin only.!!!!!!
You will need to completely dismantle the nose wheel castor assembly to
do an adequate check whereupon you just may find that the grease
retaining "o" ring isn't working allowing grease to make for easy
pivoting needing more tension applied hence the roll pin shears!
Read this and ignore it at your peril IMHO.

Regards
Bob H G-PTAG

--

- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
william(at)wrmills.plus.c
Guest
PostPosted: Tue May 30, 2006 1:38 am    Post subject: Wednesday DOTH Reply with quote
Hi Richard,
I am meeting Paddy for a doth at Old Sarum today if you can make it; but
perhaps a bit too far from Blackpool?
I'll be in touch later.
Best wishes,
William
---

- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
pete(at)lawless.info
Guest
PostPosted: Tue May 30, 2006 1:38 am    Post subject: Wednesday DOTH Reply with quote
Hi Bob

Bad luck and just when the weather was improving! Makes a mono wheel sound
almost safe.

Pete

- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
ptag.dev(at)tiscali.co.uk
Guest
PostPosted: Tue May 30, 2006 6:40 am    Post subject: Wednesday DOTH Reply with quote
Peter,
As they say watch out since there's those that have and those that will!
At least I didn't have to remember to put the gear down !
.....and those that will if they haven't inspected/improved the
castoring pivot by replacing the roll pin with a solid bolt at least !

Bob H G-PTAG Europa MKI/Jabiru 3300

--

- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
ami(at)mcfadyean.freeserv
Guest
PostPosted: Tue May 30, 2006 11:19 am    Post subject: Wednesday DOTH Reply with quote
I'm doing Sandtoft on Thursday, if that's of any interest.

Duncan McF.
do not archive
---

- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Europa-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group