Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

extrusions

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

entecrj(at)sbcglobal.net
Guest

Posted: Mon Jul 17, 2006 6:02 pm Post subject: extrusions

the attach photo out of the "Ryerson" stock list handbook, page 340 might 

shed some light on the question concerning the angle shapes.



R. Johnson / 601-HDS



do not archive

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

ryerson_book.jpg

Description:

Filesize:

264.1 KB

Viewed:

183 Time(s)

n4546v(at)mindspring.com
Guest

Posted: Mon Jul 17, 2006 8:14 pm Post subject: extrusions

Hello Russell:

    That is the Ryerson book I referred to in my earlier post.  I did not

bring up the "aluminum Association" type as that type refers to section with

three elements, i.e. web, flange and flange.  A angle section has only two

sections, i.e. flange and flange.  If you compare the Ryerson drawings with

my photo of ZA furnished extrusions, the small extrusion compares with the

"sharp corner" type, whereas the large extrusion doesn't quite compare with

either Sharp corner or American Standard as the flanges or legs have no

interior taper.  Again, ZA must have this made to their spec and is not

standard, but we seek further input.

    As another lister has just pointed out, the "American Standard" profile

of fileted web with tapered flanges is usually referred to as the

"structural" type where the "sharp corner" type is referred to as

"architectural" type.





 	  Quote: 	
		   the attach photo out of the "Ryerson" stock list handbook, page 340 might

 shed some light on the question concerning the angle shapes.



 R. Johnson / 601-HDS

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum