nuckolls.bob(at)aeroelect Guest
|
Posted: Wed Feb 17, 2021 3:54 pm Post subject: welding cable fat wire... EPDM, PVC, Neoprene? |
|
|
At 04:58 PM 2/17/2021, you wrote:
Quote: | --> AeroElectric-List message posted by: "johnbright" <john_s_bright(at)yahoo.com>
Does anyone have knowledge as to what insulation is best for OBAM welding
cable fat wires? I see choices of EPDM, PVC, and Neoprene. From what I've
seen, EPDM and PVC are rated 105C and Neoprene 150F which is 66C.
SAE J1127 is commonly cited but I haven't found a copy of it. |
I think EPDM is the most prevalent in the
consumer market. Here's one example for
materials sold by the foot and in colors
to boot.
I'd have no heartburn over this wire in
the 'fat' circuits.
Bob . . .
Un impeachable logic: George Carlin asked, "If black boxes
survive crashes, why don't they make the whole airplane
out of that stuff?"
| - The Matronics AeroElectric-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|