 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
lwinger
Joined: 21 Jun 2006
Posts: 229
Location: Tustin, CA
|
 Posted: Fri Jul 28, 2006 6:47 am Post subject: Stabilizer end rib cutout position for 601XL |
 |
|
I'm fabricating 6T1-1 and have a question about the 18mm cutout at the back of the rib. While the plans say "2 req'd" (not "1L+1R"), it appears that I don't make two identical ribs. Rather, I presume that I should make one rib with the cutout as shown, and the other rib with it on the opposite side. Is that correct?
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
Larry Winger
Tustin, CA
Plans building 601XL/650 with Corvair
Installing fuel system
www.mykitlog.com/lwinger |
|
| Back to top |
|
 |
admin(at)arachnidrobotics
Guest
|
| Posted: Fri Jul 28, 2006 7:25 am Post subject: Stabilizer end rib cutout position for 601XL |
|
|
You're right Larry. You're going to cut two identical ribs. Then
you're going to form them in OPPOSITE directions. The end result is
that you'll have one left and one right rib. If you're like many who
don't like so see the mill writing on the outside of their parts, layout
two ribs opposite of each other. Sounds like your project is coming
along. Post some pics if you get a chance.
Tom Henderson
601XL Fusealge
lwinger wrote:
| Quote: |
I'm fabricating 6T1-1 and have a question about the 18mm cutout at the back of the rib. While the plans say "2 req'd" (not "1L+1R"), it appears that I don't make two identical ribs. Rather, I presume that I should make one rib with the cutout as shown, and the other rib with it on the opposite side. Is that correct?
--------
Larry Winger
Tustin, CA
601XL #6493 from scratch
Building stabilizer & rudder parts
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=50307#50307
|
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
