 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
jesse(at)itecusa.org
Guest
|
 Posted: Sat Jan 13, 2007 5:00 pm Post subject: Powder Coat quality |
 |
|
Has anybody else on the list seen this type of quality on the powder-coated parts?
By the way, this is our solution to the axle spacer problem, without the flats yet. AN5-6A bolt through the axle nut too.
Do not archive.
Jesse Saint
I-TEC, Inc.
jesse(at)itecusa.org (jesse(at)itecusa.org)
www.itecusa.org
Cell: 352-427-0285
Fax: 815-377-3694
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
| Description: |
|
| Filesize: |
35.24 KB |
| Viewed: |
93 Time(s) |
|
|
|
| Back to top |
|
 |
nandrand(at)xtra.co.nz
Guest
|
| Posted: Sat Jan 13, 2007 11:43 pm Post subject: Powder Coat quality |
|
|
Hi. Looks as if the metal has not been prepared properly, should be dipped to remove grease,cutting fluid etc. Send it back, tell 'em to do it right.............
Regards & Fly Safe Noel
[quote] ---
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
