 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
Mike Hoffman
Joined: 11 Mar 2006
Posts: 54
|
 Posted: Fri Feb 23, 2007 5:06 pm Post subject: 701 Jury Struts |
 |
|
I have my struts installed and now I am working on the jury struts. Using the dimension on the prints, the jury strut lower horizontal (500 mm long piece) does not work out if placed 1200 mm up from the center of the lower strut mounting hole (it is to long). In addition, if I used the given location, the jury strut angel brackets that are attached to the bottom of the wing would not intersect. It looks like I have a couple of options. One would be to shorten the lower horizontal piece and install it at the given location. I would have to remove and change the bend in jury strut angle. The other option (more favorable) would be to raise the location by about 40 to 60 mm and cut down the vertical and diagonal pieces of the remaining jury strut pieces.
Has anyone else encountered this problem and if so, what changes did you make? It would be nice if there were a n assembly guide for this operation.
Thanks in advance
Mike H
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
| Back to top |
|
 |
Mike Hoffman
Joined: 11 Mar 2006
Posts: 54
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
