 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
spcialeffects
Joined: 29 Aug 2012
Posts: 306
Location: Kent
|
 Posted: Tue Apr 22, 2014 10:28 am Post subject: Hi Top 64B |
 |
|
Just a quick question. Im doing this mod on my classic and want to know just before i make the cut.....i have layed up the in fill and have clicoed the top moulding into place. I am just about to cut off the front section and want to ask is there a specific place at which to make the horizontal cut or just make it the same both sides? (this is cut 2 on the plans)
| | - The Matronics Europa-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
|
|
| Back to top |
|
 |
AirEupora
Joined: 01 Nov 2009
Posts: 186
Location: Dixon, CA
|
| Posted: Wed Apr 23, 2014 6:53 am Post subject: Re: Hi Top 64B |
|
|
I made my cut on the wind screen rear edge. I have attached two picture, but if you need more contact me off line.
Aireuropa(at)sbcglobal.net
I did the 64B mod. When I got the wind screen it was smaller than the opening so I had a lot of back filling to get it to fit.
| | - The Matronics Europa-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
| Description: |
|
| Filesize: |
683.96 KB |
| Viewed: |
2664 Time(s) |
|
| Description: |
|
| Filesize: |
739.89 KB |
| Viewed: |
2664 Time(s) |
|
|
|
| Back to top |
|
|
spcialeffects
Joined: 29 Aug 2012
Posts: 306
Location: Kent
|
| Posted: Wed Apr 23, 2014 9:12 am Post subject: Re: Hi Top 64B |
|
|
Hey thanks for the reply. I took the plunge today and made the cuts. My concern was where to make the horizontal cut, how far up the pillar. There is no defined height as long as they are the same both sides. I made the cuts 25cm up from the lower edge of the upper moulding.
| | - The Matronics Europa-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
