Fred Klein
Joined: 26 Mar 2012
Posts: 503
|
 Posted: Thu May 22, 2014 6:31 am Post subject: Clevice \Forks debacle......... |
 |
|
Bob…thank you for your attention to my build photo and for alerting me to this issue, however vexing you may find it.
I am simply baffled to learn that you find “there is already enough shit flying about on the issue” and that it’s an example showing that “people just can’t read and interpret the English language”…please do not attempt to elaborate…I can do without further discussion which you find unsuitable for posting on Matronics.
Fred
On May 22, 2014, at 2:19 AM, Bob Harrison <ptag.dev(at)talktalk.net (ptag.dev(at)talktalk.net)> wrote:
| Quote: | Hi! Tony /Fred.
To try to help you over this vexed issue concerning the clevis forks I just spoke to a local friend on the issue ....his immediate response was that he had removed ¼” but when I questioned him further he started to apply some engineering reason to the issue and suggested that we probably both removed 1/8” from each clevice to ensure there was adequate thread purchase left on both clevices. Which is the principle I would apply , the only thing better is to remove it from one and check the operational clearance as to whether it is necessary to do the other too.
I’m not publishing this on the Matronics site since there is already enough shit flying about on the issue , people just can’t read and interpret the English language !
Regards
Bob H
|
[quote][b]
| | - The Matronics Europa-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
