 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
AirEupora
Joined: 01 Nov 2009
Posts: 186
Location: Dixon, CA
|
 Posted: Tue Sep 02, 2014 6:47 am Post subject: reinstalling cylinders |
 |
|
I pulled #2 and #4 cylinder off as I had a loss of compression because of over heating.
I'm reading JEM0001-4 Overhaul Manual and on page 109 of 197, section 7.3.1, it states "Ensure the gaps are within the limits given in Table 12. 0.50 – 0.60mm is typical in a 97.60mm bore though the gap will vary depending on the exact size of the barrel."
but when you go to Table 12 it give 'N/A" under the Top End Inspection and 0.44 -1.20 under the New Clearances.
Any idea which I should follow?
Rick Stockton
N120EJ Europa
3300L 47 hours
| | - The Matronics JabiruEngine-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?JabiruEngine-List |
|
|
|
| Back to top |
|
 |
jetboy
Joined: 22 Jul 2006
Posts: 233
|
| Posted: Sun Sep 07, 2014 3:19 pm Post subject: Re: reinstalling cylinders |
|
|
its probably related to the new piston to bore clearances
Jaba chat Dec.2008 page 2
'increased from 0.002" to 0.004"
this mentioned again in advisory engine bulletin 17 - and Jaba Chat / Engine news March 2011 page 9
Advice has been that the cylinders should be honed out to twice the earlier stated clearances when removing older cylinders
So I would go with the latest info
| | - The Matronics JabiruEngine-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?JabiruEngine-List |
|
_________________
Ralph - CH701 / 2200a |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
