Carlos Sa
Joined: 13 Jan 2006
Posts: 96
|
 Posted: Thu Aug 10, 2006 5:59 pm Post subject: RE : Polished Aluminum |
 |
|
Dick, consider polishing the while the material is still flat...
I did that for the tail feathers and will be doing the same for the rest.
Have fun - and thanks for the report!
Carlos
CH601-HD, plans
Montreal, Canada
--- neitzel <n963wb(at)frontiernet.net> a écrit :
| Quote: | Polishing is going to be very labor intensive but, IMHO, will be worth the
effort. Going the polish vs. painting route, I can polish the completed
assemblies and except for touch up to remove finger prints after final
assembly, it will be done! I will not have to look at the dreaded (and
inevitable) run that I will get by spraying.
If anyone is still sitting on the fence I hope the information I have
provided is enough to push you one way or the other.
Take care and keep pulling those rivets!
Dick Neitzel
Sayner, WI
701 Jab 2200
Just finished cutting all the holes in the instrument panel and now trial
fitting the engine mount.....can't wait to hang the engine and move my bird
to the hangar.
|
p4.vert.ukl.yahoo.com uncompressed/chunked Fri Aug 11 01:23:42 GMT 2006
__________________________________________________________
Lèche-vitrine ou lèche-écran ?
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
CH601-HD, plans
Montreal, Canada |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
