Matronics Email Lists :: View topic - Installation drawing/picture of TruTrak Auto Pitch Trim

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Installation drawing/picture of TruTrak Auto Pitch Trim

Matronics Email Lists Forum Index -> RV10-List

View previous topic :: View next topic

Author Message

seipel(at)seznam.cz
Guest

Posted: Fri Aug 18, 2006 4:26 pm Post subject: Installation drawing/picture of TruTrak Auto Pitch Trim

Does anyone with the TruTrak Auto Pitch Trim have a picture of how the 

"Link Trim Sensor" gets installed?  The installation manual says "Note: 

The link sensor replaces the existing push-rod between the pitch servo 

and the control system. This sensor is required for the system to 

function; it is part of the fail safe design of the system.", but I 

can't figure out how the heck I'm supposed to do that.  The link sensor 

has a rod end bearing on one end...what do I do with the other end?  

I've emailed trutrak, but guess I need to call them as I can't seem to 

get a response.  This is one case where a picture would be worth a 

thousand words.

 	  Quote: 	
		  

 Thanks,

 PJ

 RV-10 #40032

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV10-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum