Matronics Email Lists :: View topic - 701 Pitch Control Question

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

701 Pitch Control Question

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

doug kandle

Joined: 09 Jan 2006
Posts: 33
Location: Boise ID

Posted: Fri Aug 25, 2006 3:45 pm Post subject: 701 Pitch Control Question

I am assembling my controls.  Part 7C1-3 does not appear to have the proper length shown in the drawings.  The drawing shows a total length of 685 mm.  With 10mm at each end, the bolts would have a spacing of 665 mm.



However, when I set the tail bellcrank to "neutral" I measure a required length of more like 620mm.  Looking at the drawing of 7C2-2 I would estimate that the distance should be about 625mm (this takes the 595 distance from the stick attach point to the bellcrank pivot point and adds 30mm  which is the offset for the attach point of the stick to the torque tube).



The part supplied for 7C1-3 was indeed 685mm so ZAC thinks that they need a tube this long.



As an aside - Is the "neutral" position of the stick vertical with respect to the floor or should it be slightly forward or aft?

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum