Matronics Email Lists :: View topic - Rear Wing Pin Tie-Bar in Fuselage

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Rear Wing Pin Tie-Bar in Fuselage

Matronics Email Lists Forum Index -> Europa-List

View previous topic :: View next topic

Author Message

Kelvin Weston

Joined: 14 Apr 2010
Posts: 90
Location: Hampshire, UK

Posted: Sat Mar 07, 2015 3:45 pm Post subject: Rear Wing Pin Tie-Bar in Fuselage

Hi Again

The later Cockpit Modules had a pre-moulded groove in  the rear centre tunnel to accommodate the rear wing pin tie-rod (mod 52).

Does the groove still need to be glassed over as shown in the current build manual (chap 27) thus retaining the tie-rod?

I'm thinking that this was only to restore the structural integrity of the rear tunnel on the earlier cockpit modules and is probably not required on the CM's with the pre-moulded groove.

Any thoughts?

I would be interested to hear what other builders with the later CM's have done.

- The Matronics Europa-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List

_________________
Regards

Kelv Weston
Kit 497
kelv@kdweston.co.uk

Display posts from previous:

	Matronics Email Lists Forum Index -> Europa-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum