 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
Gordon Anderson
Joined: 16 Apr 2012
Posts: 41
Location: Switzerland
|
 Posted: Tue Jul 07, 2015 2:01 pm Post subject: A-920 throttle / mixture cable |
 |
|
Does anyone have experience using the Aircraft Spruce teflon lined A-920 cables with CableSafe2 or similar fittings at each end (quadrant installation) instead of the Van's or ACS A-1550 throttle cable?
I am struggling with alignment issues using the Vans cable bracket and wonder if this arrangement might give just a little more flexibility to avoid the cable hitting the bottom of the sump. I have already "adjusted" the bracket to give as much clearance as possible, but especially on the mixture side the misalignment is more than the 8° the push-pull cable normally allows.
Gordon Anderson
Switzerland
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
| Back to top |
|
 |
flying-nut(at)cfl.rr.com
Guest
|
| Posted: Tue Jul 07, 2015 2:43 pm Post subject: A-920 throttle / mixture cable |
|
|
I too struggled with the engine cables. I didn't route the cables
through the Adel clamps on the sub-panel. Gained a little 'slack' by
going straight to the Heyco bushings.
Linn
On 7/7/2015 5:58 PM, Gordon Anderson wrote:
| Quote: |
Does anyone have experience using the Aircraft Spruce teflon lined A-920 cables with CableSafe2 or similar fittings at each end (quadrant installation) instead of the Van's or ACS A-1550 throttle cable?
I am struggling with alignment issues using the Vans cable bracket and wonder if this arrangement might give just a little more flexibility to avoid the cable hitting the bottom of the sump. I have already "adjusted" the bracket to give as much clearance as possible, but especially on the mixture side the misalignment is more than the 8° the push-pull cable normally allows.
Gordon Anderson
Switzerland
-----
No virus found in this message.
Checked by AVG - www.avg.com
|
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
