mikeshel(at)cfl.rr.com
Guest
|
 Posted: Tue Aug 18, 2015 8:32 am Post subject: Pulsar-List: Roll trim |
 |
|
Greg,
where did you find your new Pulsar with a 912? I have been searching all over since the one we talked about was not airworthy. Do you or anyone else on here have any leads on a XP with a 912?
Thank you
Mike Nuechter
----- Reply message -----
From: GREGSMI(at)aol.com
To: <pulsar-list(at)matronics.com>, <Pulsar-Aviators(at)yahoogroups.com>
Subject: Pulsar-List: Roll trim
Date: Tue, Aug 18, 2015 11:46 AM
We have a Pulsar owner wanting to install roll trim. Does anyone have a
picture he could go by?
Thanks for all the suggestions on the radio noise. I have gone through most
of the ground wires with no improvement. Yesterday, I disconnected the
capacitor that is connected to the voltage regulator, it tested good,
reinstalled it and no more static. Now I am chasing a breakup in transmission. It
occurs about every 5 seconds, like something switches off and on. It cannot
be seen in the power to the panel so I am thinking about going back to the
voltage regulator. Experimental is definitely a teaching experience in so
many different occupations.
Having fun in Kansas,
Thanks
Greg
| | - The Matronics Pulsar-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Pulsar-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
