trigo(at)mail.telepac.pt Guest
|
Posted: Tue Apr 19, 2016 2:38 pm Post subject: Powering the EFIS system |
|
|
Group
I am beginning to install the EFIS G3X system from GARMIN in the RV-10, and I have to put power into (not more not less than) 12 devices (2 Display units, 2 ADAHRS, 1 engine module, 3 autopilot servos and so on).
In some devices there are 2 independent power inputs.
I am trying to figure out which will be the best architecture for the power circuits to these 12 devices.
I know that some of you are against the single Avionics switch, and I am leaning to agree, not including that single point of failure, but how about the distribution system?
I am not searching for opinions on the breaker or fuses discussion, just to know what other people did or recommend to do with busses and circuits.
I should add that I have a dual battery /dual alternator energy system.
All good suggestions welcome!
Thanks
Carlos
Sem vĂrus. www.avast.com
| - The Matronics AeroElectric-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|