nuckolls.bob(at)aeroelect
Guest
|
 Posted: Wed Mar 15, 2017 12:43 pm Post subject: Garmin magnetometer installation considerations |
 |
|
At 02:34 PM 3/15/2017, you wrote:
| Quote: | Garmin doesn’t recommend open non-shielded wire for the GMU (twisted or not). You’ll note from the install manual is specifically calls out a 2 conductor shielded wire and a 3 conductor shielded wire (one of each) run to the GMU. This is the simplest and cleanest way to do the install as well…the wires are already twisted, already shielded and can be run together. Look at page 24-5 in the install manual (rev. AA) for details. The power, Ground and RS-232 share the three conductor wire with the shield getting sunk to the signal ground on the GMU. I’d recommend just following that install guide….after hundreds of these we’ve wired this way there hasn’t been any issues yet.
Cheers,
Stein
|
Agreed. I've got a B(at)%%-load of 3-conductor
shielded. You can use it for both the 2 and
3-conductor pathways . . . just ignore one
wire in the bundle.
How much do you need to make the necessary
runs?
Bob . . .
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
