Matronics Email Lists :: View topic - Protection for Battery Master Switch wire?

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Protection for Battery Master Switch wire?

Matronics Email Lists Forum Index -> AeroElectric-List

View previous topic :: View next topic

Author Message

nuckolls.bob(at)aeroelect
Guest

Posted: Mon Apr 09, 2018 7:46 am Post subject: Protection for Battery Master Switch wire?

At 09:30 AM 4/9/2018, you wrote:

  	  Quote: 	
		  --> AeroElectric-List message posted by: "rsmith52" <rodsmith52(at)yahoo.com>



 I plan on using Figure Z12 as the architecture for wiring my Bearhawk. In the process of converting the diagram to physical location for equipment and wire runs I noticed that the only wire that doesn't seem to have any protection, or is kept very short, is the Battery Master switch wire, 22ga running from the battery contactor to the switch? I could not find a discussion of this doing a search. 	


   There is no failure mode that puts that wire

   at risk. "Pull to ground" control lines on

   contactors have never benefited from protection. 



 

 

   Bob . . .

- The Matronics AeroElectric-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List

Display posts from previous:

	Matronics Email Lists Forum Index -> AeroElectric-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum