indigoonlatigo(at)msn.com
Guest
|
 Posted: Tue Oct 31, 2006 9:03 am Post subject: Metal Chip chasing in the empannage area |
 |
|
As you said, I can't get a large enough clamp in to place to keep the skin
tight to the backing structure to prevent the chips from dropping between.
I have chip chaser but it is too thick. I am thinking of purchasing some
long chisel shaped X-acto blades and thinning then down with a sander so
they will go between the skin and the supporting structure. I should be able
to push them out from under the skin/longeron space.
Other ideas welcome.
John G. 409
| Quote: | From: Rick <ricksked(at)earthlink.net>
Reply-To: rv10-list(at)matronics.com
To: rv10-list(at)matronics.com
Subject: Re: Empennage gap seal.
Date: Tue, 31 Oct 2006 11:15:32 -0500 (EST)
John,
I use a chip chaser, I thought it was a waste of $10 originally but it does
work well. Even better is to prevent the chips in the first place. I mask
off any cracks and such when possible to prevent them from dropping in in
the first place...not always an option though.
Rick S.
40185
|
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
