taffy0687(at)yahoo.com
Guest
|
 Posted: Sun Nov 05, 2006 7:39 am Post subject: Electric flap actuator 2" travel ? |
 |
|
Scott, Paul and all
In looking at page 6-B-19 (08/03) diagram in lower left corner it appears to me (and I could be wrong) that if you use an actuator with only 2'' of travel; the actuator or flap actuator rod ( 6-B-19-7) will hit on 6-B-5-2 before the actuator is fully extended or before "flaps full down" position. I could be wrong (my wings and flaps are off at this time) but I think the actuator travel as per the expensive (ZAC) actuator is about 2 3/4 inches. Therefore you would have to lower the hole in 6-B19-3 (flap control arm) if using an actuator with 2 inches of travel.
Again, I could be wrong, but I just wanted to mention this so someone dosn't order an actuator and than not be able to use it. Also (my opinion only) using a 2 inch travel actautor might make the flap travel speed quicker than what some folks would like. My above post definately belongs in the: "for what it is worth department.
Fritz--- 601XL- 90/90--Corvair
do not archive
---
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
