Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

P-lead shield ground

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List
View previous topic :: View next topic  
Author Message
harvey4(at)earthlink.net
Guest





PostPosted: Thu Nov 30, 2006 11:13 am    Post subject: P-lead shield ground Reply with quote

Should the shielding on p-leads for Bendix mags be grounded at both
ends or just at the "Off-Left-Right-Both-Start" switch end?

Thanks
Neil
--


- The Matronics AeroElectric-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List
Back to top
mprather(at)spro.net
Guest





PostPosted: Thu Nov 30, 2006 2:19 pm    Post subject: P-lead shield ground Reply with quote

Essentially a recurring question. Discussion on this topic can be found
in the archive quite easily. Follow the link at the bottom of each
aeroelectric email for access to the archive search tool.

An answer:

On the magneto end, the shield should be connected to the body of the
magneto (sometimes integral to the "P" lead connector) and the center
conductor should be connected to the "P" lead.

On the switch end, each shield should be connected to the "G" terminal of
the switch. The center conductor should be connected to the "L" or "R"
terminal. NO additional connections should be made (no "grounds" per se).

A picture is worth a bunch: See Figure Z-26 in the latest Z appendix
downloadable here:

http://www.aeroelectric.com/articles/Rev11/AppZ_R11J.pdf
Regards,

Matt-

Quote:

<harvey4(at)earthlink.net>

Should the shielding on p-leads for Bendix mags be grounded at both
ends or just at the "Off-Left-Right-Both-Start" switch end?

Thanks
Neil
--



- The Matronics AeroElectric-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group