Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Wing Spar Assembly Drawing 6W3, number of hat stiffeners ?

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Zenith-List
View previous topic :: View next topic  
Author Message
p.mulwitz(at)worldnet.att
Guest





PostPosted: Sun Jan 21, 2007 2:28 pm    Post subject: Wing Spar Assembly Drawing 6W3, number of hat stiffeners ? Reply with quote

Hi Masrten,

I don't have a spar handy, but I do have one scrapped out in my shop
if I need to see any details. My prints are also out in the shop.

Perhaps you need to understand the "Secret" that there are two
different XL configurations for the wing spar. They depend on the
choice of standard or extended range tanks. After you make the
choice of tankage, you need to position the nose ribs correctly to
create the single wide open area for the tank and then it may be
obvious where the hat stiffeners go for that configuration.

I hope that helps a little. if not, perhaps you could tell me which
version of the wing tanks you have chosen and I can interpret where
the hat stiffeners and nose ribs go.

Best regards,

Paul
XL fuselage
At 01:12 PM 1/21/2007, you wrote:
Quote:

<maarten.versteeg(at)swri.org>

I am confused about the number of hat stiffeners specified in the
main spar according to the latest 601XL drawings.
In item 1, on the top view of the wing spar web four hat stiffeners
are shown, on both the from view of the web and the whole spar only
3 hat stiffeners are shown. Also the description for the hat
stiffeners in item 8 lists 4 short ones and TWO long ones. So how
many hat stiffeners does the spar need to have? The rules say:
when in doubt follow the drawings, but the drawings don't seem to
be consistent here. I am scratch building the wings so I don't have
a pre-fab spar delivered, is there a kit builder who remembers his
spars ?

Maarten Versteeg San Antonio
601XL part kit part scratch
working on the wings



--


- The Matronics Zenith-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Zenith-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group