jwguitars(at)yahoo.com
Guest
|
 Posted: Mon Feb 19, 2007 7:07 pm Post subject: "Half Deep" Rivets...? |
 |
|
The last rivets in the top and bottom of the flap
skins are offset a few mm. Although this doesn't help
much if you've already drilled the holes I guess....
--- PatrickW <pwhoyt(at)yahoo.com> wrote:
| Quote: |
<pwhoyt(at)yahoo.com>
Need some advice here.
There is not enough distance depth-wise across the
narrow trailing edge of my flaps to allow for two
rivets to fit butt-to-butt.
One rivet is to be installed from the top skin of
the flap. The other rivet is to be installed from
the bottom skin of the flap. The problem is that
the holes (factory drilled) in the top skin line up
perfectly with the holes on the bottom skin.
Installation of a rivet in either the top side or
the bottom does not allow enough space for
installation of the rivet on the opposite side.
Hence my question: is there such a thing as a "half
deep" rivet?
Ideas...?
- Patrick
601XL/Corvair
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=96169#96169
|
http://answers.yahoo.com/dir/?link=list&sid=396546091
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
